Filter
Top Products
MAINTENANCE AND TROUBLESHOOTING
Inspectand properly tighten all parts of the exercise
cycle regularly. To clean the exercise cycle, use a
soft, damp cloth. To prevent damage to the console,
keep liquids away from the consoleand keep the con-
sole out of direct sunlight.
HOW TO ADJUST THE REED SWITCH
If the console does notdisplay correct feedback, the
reed switch should be adjusted. Toadjust the reed
switch, the RightSide Shield (27) must be removed.
Using an adjustable wrench, tum the Right Pedal (21)
counterclockwise and remove it. Next, remove the M4
x 25mm Screws (65). Turn the Right Crank Arm (24)
so that it is pointingtoward the front of the exercise
cycle and then slide off the Right Side Shield.
Turn the right crank arm for a moment. Repeat until
the console displays correctfeedback. When the reed
switch is correctly adjusted, reattach the right side
shield and the right pedal.
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is adjusted to the highest
level, the Drive Belt (47) may need to be adjusted. To
adjust the Drive Belt, you must first remove both side
shields. Refer to HOW TO ADJUST THE REED
SWITCH at the left and remove the side shields.
Next, locate the Reed Switch (46). Turn the Right
Crank Arm (24) until the Magnet (30) is aligned with
the Reed Switch. Loosen, but do not remove, the indi-
cated Screw (57). Slide the Reed Switch slightly clos-
er to or away from the Magnet. Then, retighten the
Screw.
Next, turn the indicated M8 Nylon Locknut (63) until
the Drive Belt (47) is properly tightened. Then, reat-
tach the side shields.
PULSE SENSOR TROUBLESHOOTING
• Avoid moving your hands while using the pulse sen-
sor. Excessive movement may interfere with heart
rate readings. Do not hold the metal contacts too
tightly; doing so may interfere with heart rate read-
ings.
• Forthe most accurate heart rate reading, hold the
metal contacts for about 15 seconds.
• For optimal performance of the pulse sensor, keep
the metal contacts clean. The contacts can be
cleaned with a soft cloth--never use alcohol,
abrasives, or chemicals.
2O