Filter
Top Products
Attach the clip to the waistband of your clothes.
Stand on the foot rails
of the treadmill. Find
the clip attached to the
key and slide the clip
onto the waistband of
your clothes. Next, in-
sert the key into the
console. Test the clip by carefully taking a few
steps backward until the key is pulled from the
console. If the key is not pulled from the con-
sole, adjust the position of the clip as needed.
Then, remove the key from the console.
Plug in the power cord.
See HOW TO PLUG IN THE POWER CORD on
page 9.
Make sure the on/off switch is in the on posi-
tion.
Locate the on/off switch
on the treadmill near the
power cord.
Make sure
the on/off switch is in the
on position.
Insert the key fully into the console.
Stand on the foot rails of the treadmill. Attach the
clip securely to the waistband of your clothes.
Next, insert the key into the console. After a
moment, the program display and the main display
will light. Note: When the key is inserted, the
treadmill incline system may automatically
calibrate itself—the treadmill will rise to the highest
incline level and then return to the lowest incline
level. During calibration, the left side of the main
display will show two dashes (– –) and the seg-
ment time indicator will flash.
Enter your weight.
Although you can use the console without enter-
ing your weight, the console will count your calorie
expenditure more accurately if you enter your
weight. To enter your weight, press either of the
Age/Weight Set buttons. The words “ENTER
WEIGHT” and the current weight setting will ap-
pear in the main display. Press the Age/Weight
Set buttons again to enter your weight. The but-
tons can be held down to enter your weight
quickly. Your weight will then be saved in memory.
To use the manual mode of the console, follow the
steps beginning on page 12. To use a preset program,
see page 14. To create and use a custom program,
see pages 16 and 17. To use a heart rate program,
see page 18. To use an iFIT.com CD or video pro-
gram, see page 22. To use an iFIT.com
program di
-
rectly from our Web site
, see page 24.
5
4
3
2
1
On
Position
GETTING STARTED
1
1
HOW TO FOLD AND MOVE THE TREADMILL
HOW TO FOLD THE TREADMILL FOR STORAGE
Before folding the treadmill, adjust the incline to the
lowest position. If this is not done, the treadmill may be per-
manently damaged. Remove the key and unplug the power
cord. CAUTION: You must be able to safely lift 45 pounds
(20 kg) to raise, lower, or move the treadmill.
1. Hold the treadmill with your hands in the locations shown
at the right.
CAUTION: To decrease the possibility of in-
jury, bend your legs and keep your back straight. As
you raise the treadmill, make sure to lift with your legs
rather than your back.
Raise the treadmill about halfway
to the vertical position.
2. Move your right hand to the position shown and hold the
treadmill firmly. Pull the latch knob to the left and hold it.
Raise the treadmill until the platform passes the pin on
the latch knob. Release the latch knob. Make sure that
the platform is resting against the pin as shown.
To protect the floor or carpet from damage, place a
mat under the treadmill. Keep the treadmill out of
direct sunlight. Do not leave the treadmill in the stor-
age position in temperatures above 30° C (85° F).
HOW TO MOVE THE TREADMILL
Before moving the treadmill, convert the treadmill to the stor
-
age position as described above.
Make sure that the catch
plate is resting against the pin on the latch knob.
1. Hold the handrails as shown and place one foot against a
wheel.
2. Tilt the treadmill back until it rolls freely on the front wheels.
Carefully move the treadmill to the desired location.
Never move the treadmill without tipping it back
. To
reduce the risk of injury, use extreme caution whilst
moving the treadmill.
Do not attempt to move the
treadmill over an uneven surface.
3. Place one foot on the base, and carefully lower the tread-
mill until it is resting in the storage position.
Base
Front Wheels
Latch
Knob
Platform
Pin
CAUTION: Before operating the
console, read the following precautions.
• Do not stand on the walking belt when turn-
ing on the power.
• Always wear the clip (see the drawing below)
whilst operating the treadmill.
• Adjust the speed in small increments to
avoid sudden jumps in speed.
• The pulse sensors are not medical devices.
Various factors may affect the accuracy of
heart rate readings. The pulse sensor is in-
tended only as an exercise aid in determin-
ing heart rate trends in general.
• If you have heart problems, or if you are over
60 years of age and have been inactive, do
not use the heart rate programs. If you are
taking medication regularly, consult your
physician to find whether the medication will
affect your exercise hart rate.
• To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console and place only a sealed water
bottle in the water bottle holder.
Clip
26