Filter
Top Products
10
7. OPERATING INSTRUCTIONS
Install the batteries according to the directions in the
section entitled “BATTERY INSTALLATION”.
Enter a dark environment.
Remove the objective lens cap by sliding it up on top of the
objective lens (2).
Turn on the unit by turning the selector switch (3) to the
“ON” position; you will see the screen light up green.
The scope can also be checked in an illuminated area, but
this is meant solely for testing the device; the lens cap (2)
must tightly cover the objective lens.
To adjust the brightness of the red reticle, turn knob (4).
To select one of the three types of the reticles, press button
(5).
Choose a remote stationary object to observe, at a distance
of about 100 m.
Turn the focusing knob (6) to “100”, it will settle into a
notch.
Observe the object through the scope and turn the diopter
focus knob (7) until the image appears crisp.
If necessary, turn on the IR illuminator by turning the
selector switch (3) to “IR” position. To mount the IR
Illuminator, unscrew and remove the plug (12) and screw
the IR clockwise.