Filter
Top Products
1515
Safety regulations:
3.4 Safety signs attached to the machine
Keep all safety plates and labels in good legible order and ensure their observance. Damaged and illegible safety
plates and labels must be renewed without delay. All plates and labels can be re-ordered from the spare parts list.
3.5 Loading the machine for transport
• Only use stable loading ramps with suffi cient load-bearing capacity. The ramp incline must not be any steeper than
the specifi ed climbing ability (see Specifi cations) of the machine.
• Safeguard the machine against tilting or slipping.
• Safeguard the machine on transport vehicles against rolling, slipping and tipping over.
• When raised, the machine must not be allowed to swing wildly.
The following situations represent a danger to life and limb:
• Walking or standing under suspended loads.
• Remaining within the driving area of the machine while it is being guided into position and loaded.
3.6 Starting the machine
3.6.1 Before starting
• The machine may only be operated from the operator‘s side (behind the machine).
• Familiarise yourself with the equipment, the operating and control elements and the functional characteristics of the
machine.
• Use personal safety gear (safety helmet, safety shoes, ear protection etc.).
Before starting, check whether:
• There are persons or impediments located next to or under the machine
• The machine is free of oily and fl ammable materials
• All handles, steps and platforms are free of grease, oil, fuels, dirt, snow and ice
• The machine exhibits any obvious defects
• All protective gear is securely in place
• Brakes and operating elements are working
Never start the machine if any instruments, pilot lamps or control organs are defective.
Do not tie any loose objects onto the machine.
3.6.2 Starting
For starting, all operating levers must be in the „Neutral position“.
After starting, check all display and operating elements.
3.6.3 Jump starting with jump leads
Note:
The machine is equipped with a 12-Volt system!
Connect the plus to the plus terminal and the minus to the minus terminal (earth cable). Connect the earth
cable last and disconnect fi rst! Incorrect connection will result in serious damage to the machine‘s electrical
system.