Filter
Top Products
TENSIONING AN EXISTING STRIDING BELT
1 Enter the Manual workout and operate the treadmill for five minutes at 5.0 MPH (8.0 KPH).
NOTE: DO NOT RUN OR WALK ON BELT.
2 Reduce the speed to 2.0 MPH (3.2 KPH). Walk on the treadmill. Tightly grip the handrails and apply force with feet
on the striding belt near the motor cover against the moving belt direction. If the belt slips, continue to Step 3. If it
does not slip, the tension is correct.
3 Using the STOP key, stop the treadmill. Turn the belt tensioning bolts a quarter-turn clockwise for each side.
4 Repeat STEPS 2 and 3 until the belt no longer slips. Do not exceed one full turn (four quarter turns) per side when
adjusting the belt tensioning bolts.
5 Enter the MANUAL workout and operate the treadmill at 2.0 MPH (3.2 KPH) check to insure proper tracking (See
Section 6.5 “How to Adjust and Tension the Striding Belt”). If the striding belt drifts to the left or right see the topic
titled Tracking (Centering) an Existing or New Striding Belt on the previous page.
Do not over-tighten the tensioning bolts while making belt adjustments. Over-tightening of bolts may over stretch and
damage the striding belt or roller bearings. Do not exceed one full turn of either bolt in either direction.
6.6 P
ROACTIVE BELT WEAR N
OTIFICATION
The treadmill proactively notifies the facility manager about belt wear through diagnostics. A single indicator is lit on the
treadmill console (if manager-enabled) when a belt check is required. This indicator light is located in the upper left cor-
ner of the workout profile window.
• Automatic belt check reminder at 30,000 miles (48,000 km)
• Notification based on “Cannot Attain Target Speed” errors for specific user weights/speeds: (The actual error
message is "UNABLE TO ATTAIN TARGET SPEED")
TO CHECK FOR NOTIFICATIONS:
To enter Belt/Deck Info, press and hold the PAUSE key and press the CLEAR key twice. Continue to hold down the
PAUSE key until the MESSAGE CENTER displays the words “SERVICE MENU”.
Then, release the PAUSE key, press the FAT_BURN key and then the ENTER_WEIGHT key. The MESSAGE CEN-
TER displays "Belt/Deck Info" and then, if a notification has been triggered, displays a notification message
"PLEASE CHECK BELT/DECK FOR SIGNS OF EXCESSIVE WEAR",`. If no notifications exist, the Belt/Deck Info
area will display belt/deck information.
NOTE: Notifications are automatically cleared once they have been displayed.
6.7 HOW TO OBTAIN PRODUCT SERVICE
1. Verify the symptom and review the operating instructions. The problem may be unfamiliarity with the product and its
features and workouts.
2. Locate and write down the serial number of the unit, which is located on a plate near the power switch.
3. Contact the nearest Life Fitness Customer Support Services group (refer to page one).
42