Filter
Top Products
10
POWER SWITCH
Located on the front panel at the base of the treadmill, the ON/OFF switch has two positions: "I" (one) for ON and "0" (zero) for
OFF.
CENTERING THE BELT
After installing and levelling the treadmill, check the belt to ensure that it is tracking properly. First, plug the power cord into an
appropriate outlet. See Electrical Requirements at the beginning of this section for details. Then, turn the treadmill ON.
Have one person stand on the platforms on either side of the treadmill frame. Do not stand on the belt at this time. Press the
QUICK START key, and increase the speed to 4.0 miles per hour (MPH), or 6.4 kilometers per hour (KPH), using the SPEED
UP arrow.
If the striding belt moves to the right while it is running, have a second person turn the right
tension bolt a quarter-turn clockwise, and then turn the left tension bolt (A) a quarter-turn
counter-clockwise. See the illustration. This action sets the striding belt tracking back to
center of the roller.
If the striding belt moves to the left, turn the left tension bolt a quarter-turn clockwise and
then turn the right tension bolt a quarter-turn counter-clockwise to start the striding belt
tracking back to center of roller.
Repeat these adjustments until striding belt appears centered. Allow the belt to continue
running for several minutes to be sure that the tracking is stabilized.
NOTE: Do not exceed one full turn of the adjusting screws in either direction. If, after one full turn, the belt does not track
properly, contact Customer Support Services. The phone numbers are listed in Section 6.7, titled How to Obtain Product
Service.