Filter
Top Products
11
FITNESS NETWORKING
The two interchangeable type RJ45 networking ports (A) are located on the back of the display console. These network
ports, located behind the display console rear access door, allow the treadmill to be connected to a fitness entertainment
system and/or a fitness network, such as FitLinxx®.
• Networking: The built-in networking ports allow the unit to exchange workout information with a fitness network
database.
• Fitness Entertainment: The network connection enables the console to power a third-party receiver for use
with a service such as the Cardio Theater
®
entertainment system or the BroadcastVision
TM
entertainment system.
POWER C
ORD ROUTING
The power cord can be run straight from the treadmill, shortened and exited out the user-front left side, or run under the
frame using the power cord clips and exited out the user right-rear side of the treadmill.
For efficient cord management, the following routing options are recommended:
With the power cord unplugged, insert the clips in the appropriate holes. See the illustration below. Use Hole Pattern 1
or 2 to locate the clips and secure the power cord with the clips, taking up any slack between clips.
NOTE: It may be necessary to tip the treadmill to route the power cord properly.
To plug the power cord into an outlet in front of the treadmill, use Hole Pattern 1 for outlets located at the front of the
machine.
NOTE: To accommodate treadmill incline, at least two feet (24”) of power cord is required between the outlet and the
last power cord clip for outlets in front of the treadmill.
To plug the power cord into an outlet in rear of the treadmill, use Hole Pattern 2 for outlets located at the rear of the
machine.
WARNING: Make sure that there is a 6-foot clearance behind the
treadmill. Contact Life Fitness Customer Service for an optional
longer power cord if necessary.
WARNING: Insure that the power cord (A) does not contact the strid-
ing belt or get pinched between the frame (C), lift arm (B) or the
wheel; failure to follow this warning may result in serious injury.
AVERTISSEMENT : S'assurer que le cordon d'alimentation n'entre pas
en contact avec le tapis et ne soit pas pincé entre le cadre, le bras de
levage ou la roue. Le non-respect de cet avertissement peut provo-
quer de graves blessures.
NOTE: When using Pattern 1, it is extremely important to route the power cord BETWEEN the lift frame and the main
frame.
A