Filter
Top Products
35
T
RACKING (CENTERING) A STRIDING BELT
Two people are needed to perform this procedure.
1 Locate the two access holes to the belt tensioning bolts on each of the rear roller guards.
2 Stand on the sides of the treadmill and straddle the belt, not standing on it. Start a MANUAL
workout, and set the belt speed to run at 4.0 mph (6,4 kph).
3 If the striding belt has moved to the right, turn the right tension bolt (B) 1/4 turn clockwise
with provided ¼" Allen wrench, and then turn the left tension bolt (A) 1/4 turn counter-clock-
wise to start striding belt tracking back to center of roller.
If the striding belt has moved to the left, turn the left tension bolt 1/4 turn clockwise and then
turn the right tension bolt 1/4 turn counter-clockwise to start striding belt tracking back to
center of roller. Repeat adjustments until striding belt appears centered. Allow machine to
continue running for several minutes to observe if tracking remains stabilized.
NOTE: Do not exceed one full turn of the adjusting screws in either direction. If after one full
turn the belt does not track properly, contact Customer Support Services. The phone num-
bers are listed in "How to Obtain Product Service."
NOTE: Do not exceed one full turn of the adjusting screws in either direction. If after one full
turn the belt does not track properly, contact Customer Support Services. The phone numbers
are listed in Section 6.7, titled How to Obtain Product Service.
AB