Filter
Top Products
3.2 PACKAGING
Parts: None
Remove all packaging and place main components to the side of the box. Break box down in each of the four corners.
Note: Support pedal levers when removing internal packaging to prevent damage to the pedals.
3.3 ASSEMBLE THE STABILIZERS
Parts: Hardware Bag #1 (4, M10 X 15mm Silver Hex Head Bolts)
Tools: 17mm Socket Wrench
Assemble the stabilizer tubes (feet) (A) to the bottom base brackets (B) of the product using two M10 X 15mm Hex
Head Bolts (1) on each stabilizer tube. Both stabilizer tubes (feet) are identical.
3.4 ASSEMBLE THE CONSOLE UPRIGHT
Parts: Hardware Bag #2 (3, M10 X 74mm Silver Hex Head Bolts)
(1, M10 X 20mm Silver Hex Head Bolt)
Tools: 17mm Socket Wrench
The console upright tube (C) is pre-assembled with one bolt so that you can simply lift the upright into place by pivoting
upward. Hold the upright in place and install three M10 X 74mm Silver Hex Head Bolts (2) into the side of the main
bracket (D). Install one M10 X 20mm Silver Hex Head Bolt (3)
into the front of the bracket.
CAUTION: Do not pinch wires when assembling the upright.
3.5 CONNECT BASE WIRING
Parts: None
Connect the two wires (E) at the base of the upright.
C
2
D
1
B
A
9
3
D
E