Filter
Top Products
• Screw the threaded end of the CABLE (14) approximately 3/4” into the end of the 20 HOLE SELECTOR SHAFT (16) and tighten jam
nut securely. See FIGURE 17.
• If the HEAD PLATE (17) does not sit on top of the first WEIGHT PLATE (29), push the head plate down, insert the SELECTOR PIN
(23) and perform several repetitions on the machine. This will relax the cable system and prevent the HEAD PLATE (17) from lifting up.
• If after completing the previous step the HEAD PLATE (17) still does not sit on top of the first WEIGHT PLATE (29) or if there is
excess slack in the cable system, adjust the threaded end of the CABLE accordingly and retighten the jam nut.
FIGURE 17
16
STEP 17:
14
17
23
29