Filter
Top Products
0
1
2
3 4 5
6
1/2 1/2 1/2 1/2 1/2 1/2
12
FIGURE 10
STEP 12:
• Insert two GUIDE RODS (13) into the base of
the TOWER (1) as shown in FIGURE 10.
Lubricate the GUIDE RODS (13) with a slicon
or teflon spray that is available at most
hardware stores.
• Slide two RUBBER BUMPERS (21) down
over the GUIDE RODS (13). See FIGURE 10.
• Using EXTREME CARE slide twenty WEIGHT
PLATES (29) down over the GUIDE RODS (13)
with the key-hole facing as shown in FIGURE
10.
• Securely assemble the 20 HOLE SELECTOR
SHAFT (16) to the HEAD PLATE (17) using
one 3/8 X 1-1/4” BOLT (31) and one 3/8”
WASHER (36). (Note: The bolt hole in the
HEAD PLATE (17) should be on top.)
• Carefully Slide the HEAD PLATE ASSEMBLY
(16 & 17) down over the GUIDE RODS (13)
onto the weight stack as shown in FIGURE 10.
• Apply one set of WEIGHT STACK LABELS -
LBS. OR 1-25 (42) (43) to each WEIGHT
PLATE (29) as shown in FIGURE 10.
• Slide two 13/16” SHAFT COLLARS (26) over
the GUIDE RODS (13) as shown in FIGURE
10.
13
3/8 X 1-1/4” 31
17
36
16
29
21
1
42
43
26