Filter
Top Products
STEP6 (See Diagram 6)
A.) Attach the Bench Press Base (#14) to the opening on the Rear Vertical Beam (#6). Carefully
place two ∅1 ½” x Ø 1” Washers (#132) in between the Base and the Rear Vertical Beam. Align
the holes and insert a 9” Axle (#32). Secure both ends with two ∅1 ½ x ∅ ½”Washers (#133)
and M12 Aircraft Nuts (#127). Do not over tighten the Nuts. Make sure the Base is free to swivel
on the Axle. Close both ends with two Cone-shaped End Caps (#105).
B.) Attach four ∅1” Bushings (#67) to the openings on the Bench Press Frame (#13). Attach the
Bench Press Frame to the Bench Press Base (#14). Align the holes and insert a 13 ¾” Axle
(#33). Secure both ends with two ∅1 ½” x ∅ ½” Washers (#133) and M12 Aircraft Nuts (#127).
Close both ends with two Cone-shaped End Caps (#105).
C.) Lubricate the inside of the Foam Grips (#72) with water then slide them onto the Bench Press
Frame (#13).
D.) To adjust the Bench Press Arm, simply squeeze down the break handle on the right side of the
Press Arm.
DIAGRAM 6
12