Filter
Top Products
STEP 5 (See Diagram 5)
A.) Install 19 Weight Plates (#58). To install the plates, hold the plate at an angle and place between
the two Guide Rods (#10) then drop it down. Make sure the grooves on the plastic covers all
face up. The plates should all interlock with each other. It is strongly recommended to spray
lubricant such as WD-40 on the Guide Rods to minimize friction.
B.) Insert the Selector Rod (#62) into the center hole on the Weight Plates. Slide the Selector Stem
(#63) onto the Guide Rods from the top. Align the holes. Secure it to the Selector Rod with one
M10 x 1 ¾” Allen Bolt (#119).
C.) Insert the Weight Plate Selector Pin (#73) in between two plates to select the number of weight
plates for exercise and to secure the Selector Rod. Make sure the magnet on the Pin faces up.
D.) Attach the Top Socket Assembly (#9) to the Upper Frame and top of the Guide Rods. Secure it
to the Upper Frame with two M10 x 2 ¾” Carriage Bolts (#109), one 4 ¾” x 2 ¾” Bracket (#45),
two Ø ¾” Washers (#124), and two M10 Aircraft Nuts (#128).
E.) Secure the Top Socket Assembly (#9) to the Guide Rods (#10) with two M10 x ¾” Allen Bolts
(#120) and Ø ¾” Washers (#124).
11