Filter
Top Products
STEP 17 Tension Cable looping (See Diagram 17)
A.) Thread the bolt on the 161” Tension Cable (#56) into the Single Floating Pulley Bracket (#23)
previously installed.
B.) Remove the Cable Strap Bracket from the other end of the Cable.
C.) Draw the Cable down to the oblique Pulley on the Main Base Frame. Draw the Cable
underneath the Pulley then pull upward to the lower Pulley on the Angled Double Floating
Pulley Bracket (#26) previously installed.
D.) Draw the Cable around the Pulley then pull downward to the other oblique Pulley on the Main
Base Frame.
E.) Draw the Cable underneath the Pulley then pull upward to the lower Pulley on the Double
Floating Pulley Bracket (#27) previously installed.
F.) Draw the Cable over the Pulley then pull downward to the post on the Main Base Frame.
Attach the end of the Cable to the Cable Strap Bracket (#45). Secure the Strap to the post
with one M8 x 1 ¼” Allen Bolt (#110) and M8 Aircraft Nut (#124).
G.) Securely tighten all Nuts and Bolts previously installed.
H.) Check the tightness of the Cable Loop System.
26