Filter
Top Products
STEP 16 Butterfly Cable Looping (See Diagram 16)
A.) Attach one end of the 99” Butterfly Cable (#55) to the bottom of the Right Butterfly (#6).
Secure it with the M10 x 1 5/8” Allen Bolt (#100), Ø 7/8” x ½” Spacer (#80), two Ø ¾”
Washers (#118), and one M10 Aircraft Nut (#125) on the Bracket.
B.) Remove the Cable Strap Bracket from the other end of the Cable.
C.) Pull the Cable towards the back of the machine to the right oblique Pulley on the Main Base
Frame behind the Front Vertical Beam.
D.) Draw the Cable underneath the Pulley then pull upward to the lower Pulley on the Angled
Double Floating Pulley Bracket (#26). Draw the Cable around the Pulley then downward to
the left oblique Pulley on the Main Base Frame.
E.) Draw the Cable underneath the Pulley then pull to the Left Butterfly (#7).
F.) Repeat the Step A above to secure the end Cable to the Left Butterfly.
25