9. 9
The Console (10) requires four "D" batteries
(not included); alkaline batteries are recom-
mended. IMPORTANT: If the elliptical exer-
ciser has been exposed to cold tempera-
tures, allow it to warm to room tempera-
ture before inserting batteries into the
Console. If you do not do this, the console
displays or other electronic components
may become damaged. Remove the battery
cover from the bottom of the Console and
insert four batteries into the battery compart-
ment. Make sure the batteries are oriented
as shown by the diagram inside the battery
compartment. Then, reattach the battery
cover.
Have a second person hold the Console (10)
near the Upright (2) as shown. Connect the
console wires to the Upper Wire Harness (18)
and the Pulse Wire (11). Attach the Console
(10) to the Upright (2) with four M4 x 16mm
Round Head Screws (93). Be careful to
avoid pinching the wires.
93
11
18
Console Wires
10. Identify the Left Upper Body Arm (4), which is
marked with a "Left" sticker. Orient the Left
Upper Body Arm so that the indicated tube is
facing inward.
Lubricate the upper end of the left Upper
Body Leg (6) using a small amount of the
included high-temperature lubricant. Then,
slide the Left Upper Body Arm (4) onto the
Upper Body Leg.
Apply a generous amount of grease to the
Pivot Axle (16). Then, insert the Pivot Axle
through the Left Upper Body Arm (4), an
Upper Body Arm Spacer (29), and the
Upright (2). Make sure the Upper Body Arm
Spacer is oriented as shown, with the
arrow pointed down.
10
Grease _.
29
Lubricate
10