Filter
Top Products
12
20. Turn the Seat (14) as shown. Attach the wide end
of the Seat to the bracket on the Seat Mounting
Bracket (23) with two M6 x 16mm Screws (3).
Tilt the Seat Mounting Bracket (23) upwards and
attach the narrow end of the Seat (14) to the Seat
Mounting Bracket with an M6 x 35mm Bolt (34) and
an M6 Washer (30).
20
3
34
30
23
14
Bracket
22. Insert three 45mm Square Inner Caps (40) into the
ends of the Leg Lever (17). Insert a 25mm Round
Inner Cap (39) into the weight tube on the Leg Lever.
Press a 25mm Angled Outer Cap (38) onto the other
end of the weight tube.
Attach the Leg Lever (17) to the Adjustable Bench
Leg (2) with an M10 x 70mm Bolt (21) and an M10
Nylon Locknut (11). Note: Do not over tighten the
M10 Nylon Locknut; the Leg Lever must pivot
easily.
23. Insert 19mm Round Inner Caps (26) into the ends of
the three Pad Tubes (16).
Insert two Pad Tubes (16) through the holes in the
Leg Lever (17). Slide a Foam Pad (25) onto each
side of the Pad Tubes.
Insert a Pad Tube (16) through the upper tube on the
Adjustable Bench Leg (2). Slide a Foam Pad (25)
onto each side of the Pad Tube.
22
Weight
Tube
39
40
21
11
38
40
17
2
40
23
17
26
25
25
2
26
25
16
25
25
26
21. Attach the Adjustable Bench Leg (2) to the Bench
Leg (1) with the Adjustment Knob (37).
Insert a 45mm Square Inner Cap (40) into the top
of the Adjustable Bench Leg (2).
21
1
2
40
37