Filter
Top Products
10
13. Press a 50mm x 70mm Outer Cap (10) onto each
end of the Stabilizer (13).
Attach the Stabilizer (13) to the Bench Frame (5)
with two M10 x 60mm Button Head Bolts (12) and
two M10 Nylon Locknuts (11). Note: Position the
Stabilizer so that the warning decal is in the
position shown.
Note: Do not tighten the Nylon Locknuts yet.
13
12
10
11
5
13
Decal
10
14. Press a 50mm Square Outer Cap (20) onto each
end of the Bench Base (7).
Attach the Bench Base Joint Plate (19) to the Bench
Base (7) with two M10 x 70mm Bolts (21), two M10
Washers (6), and two M10 Nylon Locknuts (11).
Attach the Bench Leg (1) to the Bench Base Joint
Plate (19) with two M10 x 70mm Bolts (21), two M10
Washers (6), and two M10 Nylon Locknuts (11).
Be sure the welded nut is in the position shown.
Note: Do not tighten the Nylon Locknuts yet.
14
21
6
6
21
6
6
1
Welded Nut
11
19
20
20
7
12. Attach the upper end of one of the Weight Guides
(53) to the bracket on the Upright (43) with an M8 x
30mm Bolt (64) and an M8 Washer (77).
Attach the other Weight Guide (53) to the other
Upright (43) in the same manner.
Tighten all of the Nylon Locknuts used in steps 1
to 12.
64
53
77
43
12
15. Attach the Bench Leg (1) to the Bench Frame (5)
with two Bench Joint Plates (18), four M10 x 70mm
Bolts (21), and four M10 Nylon Locknuts (11).
Note: Tighten all the Nylon Locknuts used in
steps 13-15.
15
1
11
18
5
21
18