Filter
Top Products
8
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
TREADMILL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
9
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
TREADMILL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
A Open BLUE HARDWARE BAG.
B Connect the CONSOLE WIRES
from the CONSOLE to those from
the top of the MAST.
C Attach CONSOLE to the
CONSOLE MASTS using
1 BOLT (D).
D Repeat on other side.
E Tighten all console bolts.
F Snap each of the CUP HOLDERS
firmly into the CONSOLE.
NOTE: During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before
completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of hardware.
Any grease, such as lithium bike grease is recommended.
P R E - A S S E M B LY
A S S E M B LY S T E P 1
BOLT (A)
15 mm
Qty: 6
ARC WASHER (C)
8 mm Diameter
Qty: 6
SPRING WASHER (B)
8 mm DIAMETER
Qty: 6
PINK HARDWARE BAG CONTENTS :
A S S E M B LY S T E P 2
BOLT (D)
20 mm
Qty: 2
BLUE HARDWARE BAG CONTENTS :
BOLT (A)
SPRING WASHER (B)
WASHER (C)
CONSOLE MAST
BASE FRAME
CONSOLE WIRES
BOLT (D)
CONSOLE
SUGGESTED METHOD FOR STARTING BOLT
CONSOLE WIRES
A Open PINK HARDWARE BAG.
B Connect the CONSOLE WIRES
from the BASE FRAME to the
bottom of the CONSOLE MAST.
C Attach LEFT CONSOLE MAST
using 3 BOLTS (A), 3 SPRING
WASHERS (B) and 3 ARC
WASHERS (C).
D Repeat on other side.
CUP HOLDER
* NOTE: Be careful not to pinch any
wires while assembling the masts.
* NOTE: Be careful not to pinch any
wires while assembling the console.
T4_T6_Rev.1.7.indd 8-9 10/19/06 9:21:57 AM