Filter
Top Products
TSC
2
10
QUICK START UP
Simply press the Start button to begin exercising.
PAUSE
Press the Stop button to pause your workout.
RESET
Press and hold the Stop button to reset the treadmill.
GETTING STARTED
S
.
Class Series
31
TENSIONING THE BELT
If you can feel a slipping sensation when running on the treadmill, the running belt
must be tightened. In most cases, the belt has stretched from use, causing the belt
to slip. This is a normal and common adjustment. To eliminate this slipping, ten-
sion both the rear roller bolts with the appropriate size allen wrench, turning it
1/4 TURN to the right as shown. Try the
treadmill again to check for slipping.
Repeat if necessary, but NEVER TURN
the roller bolts more than 1/4 turn at a
time. the belt tension is set properly
when the running belt is 1/4 of an inch
from the deck.
CENTERING THE BELT
If the running belt is too far to the right side, use the supplied Allen wrench to turn
the right tension bolt clockwise 1/4 turn at a time until the belt remains centered
during use.
If the running belt is too far to the left side, turn the left tension bolt clockwise
1/4 turn at a time until the belt remains centered during use.
IF THE BELT IS TOO FAR TO
THE LEFT SIDE:
• Turn the left roller bolt 1/4 turn
clockwise (tighten).
IF THE BELT IS TOO FAR TO
THE RIGHT SIDE:
• Turn the right roller bolt 1/4 turn
clockwise (tighten).
s.class MANUAL v1.0.qxd 2/19/2003 10:49 AM Page 11