Filter
Top Products
BEFORE
YOU BEGIN
10
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
11
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
A S S E M B LY ST E P 3
A) Open HARDWARE BAG FOR STEP 3.
B) Remove PRE-ATTACHED BOLT & WASHERS from CRANK.
C) Slide PEDAL ARM onto CRANK and attach by re-inserting PRE-ATTACHED BOLT and WASHERS.
D) Repeat on the other side.
E) Attach the PEDAL ARM COVER to the right PEDAL ARM using 1 SCREW (F).
F) Repeat on the other side.
CRANK
PRE-ATTACHED BOLT AND WASHERS
SCREW (F)
PEDAL ARM COVER
PEDAL ARM
SCREW (F)
15 mm
Qty: 2
HARDWARE BAG FOR STEP 3 CONTENTS :
A S S E M B LY ST E P 4
RIGHT HANDLEBAR
PRE-ATTACHED BOLT AND WASHERS
HANDLEBAR COVER
CONSOLE MAST
BOLT (G)
MULTI-POSITION HANDGRIPS
A) Open HARDWARE BAG FOR STEP 4.
B) Attach the MULTI-POSITION HANDGRIPS to the right HANDLEBAR using 2 BOLTS (G).
C) Remove PRE-ATTACHED BOLT & WASHERS from CONSOLE MAST.
D) Slide RIGHT HANDLEBAR onto CONSOLE MAST and attach by re-inserting PRE-ATTACHED BOLT & WASHERS.
After handlebars are assembled they will rotate freely – be cautious. Until the
machine is fully assembled, do not grab the handlebars for support.
E) Snap HANDLEBAR COVERS together over the RIGHT HANDLEBAR. Note the position of the snap tabs on the
covers before snapping into position.
F) Repeat on other side.
WARNING
BOLT (G)
15 mm
Qty: 4
HARDWARE BAG FOR STEP 4 CONTENTS :
EX-77_Rev.1.6.indd 10-11 7/1/08 8:17:43 AM