Filter
Top Products
BEFORE
YOU BEGIN
8
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
9
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
TOP CAP
CONSOLE MAST BOOT
CONSOLE MAST
MAIN FRAME
CONSOLE WIRE
FLAT WASHER (D)
SPRING WASHER (C)
BOLT (B)
ARC WASHER (E)
A S S E M B LY ST E P 2
A) Open HARDWARE BAG FOR STEP 2.
B) Slide the CONSOLE MAST BOOT followed by the TOP CAP
over the CONSOLE MAST
.
C)
Carefully pull the CONSOLE WIRES through the CONSOLE MAST using the twist tie located inside the
CONSOLE MAST.
D) Attach the sides of the CONSOLE MAST to the MAIN FRAME using 4 BOLTS (B), 4 SPRING WASHERS (C) and 4
FLAT WASHERS (D).
E) Attach the front of the CONSOLE MAST to the MAIN FRAME using 2 BOLTS (B), 2 SPRING WASHERS (C) and 2
ARC WASHERS (E).
F) Slide TOP CAP and CONSOLE MAST BOOT down to seal the console mast hole.
BOLT (B)
15 mm
Qty: 6
SPRING WASHER (C)
15.4 mm
Qty: 6
FLAT WASHER (D)
20 mm
Qty: 4
ARC WASHER (E)
17 mm
Qty: 2
HARDWARE BAG FOR STEP 2 CONTENTS :
TOP CAP
CONSOLE MAST BOOT
CONSOLE MAST
MAIN FRAME
CONSOLE WIRE
FLAT WASHER (D)
SPRING WASHER (C)
BOLT (B)
ARC WASHER (E)
A S S E M B LY ST E P 1
A) Open HARDWARE BAG FOR STEP 1.
B) Attach the FRONT STABILIZER TUBE to the the MAIN FRAME
using 2 BOLTS (A)
.
BOLT (A)
20 mm
Qty: 2
HARDWARE BAG FOR STEP 1 CONTENTS :
FRONT STABILIZER TUBE
BOLT (A)
MAIN FRAME
EX-77_Rev.1.6.indd 8-9 7/1/08 8:17:38 AM