Filter
Top Products
BEFORE
YOU BEGIN
16
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
17
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
A) Open HARDWARE BAG FOR STEP 6.
B) Attach FOOTPAD to FOOT PLATE using 4 BOLTS (K)
.
C) Slide WAVY WASHER (L) and the FOOT PLATE onto the PEDAL ARM axle.
D) Attach FOOTPAD BRACKET to FOOT PLATE using 3 BOLTS (M)
.
E) Repeat on other side.
A S S E M B LY S T E P 6
HARDWARE BAG FOR STEP 6 CONTENTS :
2.2E ASSEMBLY
Y O U ’ R E FI N I S H E D !
A S S E M B LY S T E P 8
NOTE: There is NO hardware bag
for this step. All hardware is pre-
installed.
A) Attach the CONSOLE WIRES.
B) Carefully tuck the CONSOLE
MAST wires into the CONSOLE
MAST before attaching the
CONSOLE.
C) Attach CONSOLE to the
CONSOLE MAST using the
4 PRE-ATTACHED SCREWS
(screws will have to be removed
from the console first).
DO NOT PINCH WIRES!
A) Open HARDWARE BAG FOR STEP 7.
B) Remove PRE-ATTACHED BOLT &
WASHERS from CONSOLE MAST.
C) Slide LOWER HANDLEBARS onto
CONSOLE MAST and attach by
re-inserting PRE-ATTACHED BOLT
& WASHERS.
D) Attach UPPER HANDLEBARS to
LOWER HANDLEBARS using PRE-
ATTACHED SCREWS.
D) Attach HANDLEBAR COVERS using
4 SCREWS (J).
ASSEMBLY STEP 7
HARDWARE BAG FOR STEP 7 CONTENTS :
Elite 1.2E 2.2E Rev.1.0.indd 16-17 7/19/05 8:20:41 AM