Filter
Top Products
BEFORE
YOU BEGIN
10
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
11
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
1.2E ASSEMBLY
A) Open HARDWARE BAG FOR STEP 6.
B) To attach LOWER LINK ARM to
PEDAL ARM, slide SPACER (J),
FLAT WASHER (K) and WAVY
WASHER (L) onto PEDAL ARM
BRACKET.
NOTE: Attaching the lower link arm
assembly to the pedal arm first
makes assembly of the linkage
arms less difficult.
C) Slide LOWER LINK ARM onto
PEDAL ARM BRACKET, followed by
FLAT WASHER (M) and
BOLT (N).
D) Repeat on other side.
E) Slide LOWER LINK ARM onto
UPPER HANDLEBAR and attach
using 2 PRE-ATTACHED SET
SCREWS.
F) Attach HANDLEBAR COVERS using
2 SCREWS (O).
G) Repeat on other side.
HARDWARE BAG FOR STEP 6 CONTENTS :
ASSEMBLY STEP 6
NOTE: There is NO hardware bag
for this step. All hardware is pre-
installed.
A) Pull TENSION CABLE out from
square hole in console mast.
B) Turn RESISTANCE KNOB to highest
resistance setting. Place the
TENSION WIRE into the BOTTOM
KEY HOLE on the RESISTANCE
KNOB BRACKET.
C) While holding the RESISTANCE
KNOB BRACKET, pull the
RESISTANCE KNOB up to slide it
into the TOP KEY HOLE position on
the RESISTANCE KNOB BRACKET.
D) Once the TENSION WIRE is in
position, turn the RESISTANCE
KNOB to the lowest resistance
setting.
E) Slide RESISTANCE KNOB &
BRACKET into the CONSOLE MAST
and attach using PRE-INSTALLED
BOLT & WASHER.
F) Attach the CONSOLE WIRES (2
heart rate wires and 1 speed
sensor wire).
G) Carefully tuck the CONSOLE WIRES
into the CONSOLE MAST before
attaching the CONSOLE.
H) Attach CONSOLE to the CONSOLE
MAST using the 2 PRE-ATTACHED
SCREWS (screws will have to be
removed from the console first).
DO NOT PINCH WIRES!
ASSEMBLY STEP 7
Y O U ’ R E FI N I S H E D !
STEPS A-E
STEPS F-H
Elite 1.2E 2.2E Rev.1.0.indd 10-11 7/19/05 8:20:19 AM