Filter
Top Products
BEFORE
YOU BEGIN
14
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
15
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
A) Open HARDWARE BAG FOR STEP 3.
B) Slide the CONSOLE MAST BOOT over the bottom of the CONSOLE MAST.
C) Carefully pull console wires through the CONSOLE MAST. Attach the CONSOLE WIRES to the pre-attached
routing wire. Discard wire when finished.
D) Slide CONSOLE MAST into MAIN FRAME.
E) Insert 3 BOLTS (C), 3 LOCK WASHERS (D) and 3 ARC WASHERS (E) into back of CONSOLE MAST.
F) Attach CONSOLE MAST to MAIN FRAME using BOLT (B) using NUT (F).
G) Slide CONSOLE MAST BOOT down to cover exposed bolts.
HARDWARE BAG FOR STEP 3 CONTENTS :
ASSEMBLY STEP 3
2.2E ASSEMBLY
A) Open HARDWARE BAG FOR STEP 5.
B) Remove PRE-ATTACHED BOLT &
WASHERS from CONSOLE MAST.
C) Slide LOWER HANDLEBARS onto
CONSOLE MAST and attach by
re-inserting PRE-ATTACHED BOLT
& WASHERS.
D) Attach UPPER HANDLEBARS to
LOWER HANDLEBARS using PRE-
ATTACHED SCREWS.
D) Attach HANDLEBAR COVERS using
4 SCREWS (J).
A) Open HARDWARE BAG FOR STEP 4.
B) Place TEFLON WASHER (H) over
CRANK ARM followed by PEDAL
ARM.
C) Place a second TEFLON WASHER
(H) over PEDAL ARM and attach
using NUT (G).
D) Repeat on other side.
E) Attach PEDAL ARM COVERS to
PEDAL ARMS using SCREWS (I).
HARDWARE BAG FOR STEP 4 CONTENTS :
ASSEMBLY STEP 4
ASSEMBLY STEP 5
HARDWARE BAG FOR STEP 2 CONTENTS :
Elite 1.2E 2.2E Rev.1.0.indd 14-15 7/19/05 8:20:38 AM