Filter
Top Products
9
1
STEP 1:
ATTACH REAR FOOT TUBE.
Note: Make sure not to tighten
bolts until all assembly steps have
been completely assembled and
aligned.
STEP 2:
ATTACH SEAT BACK CUSHION/
COVER AND SEAT BOTTOM.
Note: The seat back cushion is
attached with four 40mm bolts
and then the seat back cover
snaps into place.
STEP 3:
ATTACH HANDLEBAR.
Note: Connect the grip pulse wires
from the seat back to the handle-
bar. DO NOT PINCH WIRES!
A
2
3
4 5 6
7
8
STEP 4:
ATTACH LEFT & RIGHT PEDALS.
Note: Both pedals are labeled L
for left and R for right. To tighten
turn the left pedal COUNTER
CLOCKWISE and the right pedal
CLOCKWISE.
STEP 5:
ATTACH SEAT RAIL TO BASE
FRAME.
Note: Slide seat post and seat rail
boot on seat rail before you tighten
bolts.
STEP 6:
ATTACH CONSOLE MAST AND
CONSOLE MAST BOOT.
Note: Make sure to loosen the
water bottle screws in order to fit
the console cable through the
mast. DO NOT PINCH WIRES!
STEP 7:
ATTACH TENSION KNOB. (2.1R only)
Note: Bolt is pre-assembled to tension knob.
The resistance indicator is located on the front of the
tension knob.
STEP 8:
ATTACH CONSOLE.
Note: DO NOT PINCH WIRES!
Note: Bolt is pre-assembled to console.
L
R
B
C
D
D
D
B
C