Filter
Top Products
7
Assembly
UNPACKING
Unpack the product where you will be using it. Place the product on a level flat surface. It is recom-
mended that you place a protective covering on your floor. Note: It is recommended that you apply
grease to the threads of each bolt as you assemble the product, to prevent loosening and noise. Also,
during each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in
before completely tightening any ONE bolt.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY! Place your recumbent
on a level flat surface. It is recommended that you place a protective covering on your floor.
PARTS
• 1 Rear Foot Tube
• 1 Handlebar
• 1 Seat Rail
• 1 Seat Rail Boot
• 1 Seat Back
• 1 Seat Front
• 1 Seat Bottom
• 1 Seat Frame
• 1 Console Mast
• 1 Console Mast Boot
• 2 Mobile Wheel/Sleeves
• 1 Console
• 2 Pedals
• 1 Tension Knob (2.1R only)
• 1 Power Supply (2.1R, 3.1R models)
• 1 Hardware Pack
TOOLS (included)
• 5mm Allen Wrench/Phillips Screw Driver
• Flat Wrench
If you have any questions, or if there are any missing parts, we will guarantee complete satisfaction.
PLEASE CALL OUR TOLL-FREE DIRECT CUSTOMER ASSISTANCE CENTER @ 1-800-244-4192
Mon.-Fri., 8 a.m.-5 p.m. CST (excluding holidays).