Filter
Top Products
8
2. Have a second person hold the Right Upright
(88) near the Right Base Cover (117). See the
inset drawing. Locate the wire tie in the rectan-
g
ular hole in the bottom of the Right Upright. Tie
the wire tie securely around the end of the
U
pright Wire (86). Then, pull the other end of the
wire tie until the Upright Wire is routed com-
pletely through the Right Upright.
Gently pull up on the Upright Wire (86) as you
set the Right Upright (88) on the Base (115) in-
side the Right Base Cover (117). Be careful not
to pinch the Upright Wire.
Attach the Right Upright (88) to the Base (115)
with two 3/8" x 3 3/4" Patch Bolts (2) and two
3/8" Star Washers (8); do not fully tighten the
Patch Bolts yet. Note: It may be necessary to
tip the top of the Right Upright forward slightly
and rotate the bottom as you thread the Patch
Bolts into the Right Upright.
117
Wire
T
ie
2
88
86
2
8
86
88
3. Have a seond person hold the Left Upright (85)
near the Left Base Cover (118). See the inset
drawing. Locate the wire tie in the rectangular
hole in the bottom of the Left Upright.Tie the wire
tie in the Left Upright securely around the end of
the 50" TV Cable (81) and the 50" A/V Wire
(80).
Then, pull the other end of the wire tie until the
50" TV Cable (81) and the 50" A/V Wire (80) are
routed completely through the Left Upright (85)
Gently pull up on the wires as you set the Left
Upright on the Base (115) inside the Left Base
Cover (118). Be careful not to pinch the
wires.
Attach the Left Upright (85) to the Base (115)
with two 3/8" x 3 3/4" Patch Bolts (2) and two
3/8" Star Washers (8); do not fully tighten the
Patch Bolts yet. Note: It may be necessary to
tip the top of the Left Upright forward slightly
and rotate the bottom as you thread the Patch
Bolts into the Left Upright.
With the help of a second person, lower the
treadmill off the cardboard stand. The stand will
be used again in assembly step 8.
118
115
3
8
2
85
81
80
115
Cardboard
Stand
80
81
85
Wire
Tie
Wire
Tie
Wire
Tie