Filter
Top Products
11
10. Note the location of the 75 ohm terminal and the
audio/video input jack on the treadmill. For the
television to operate, an antenna or a CATV
cable must be connected to the 75 ohm terminal
or the 96" A/V Wire (101) must be connected to
the audio/video input jack (see page 13).
10
11. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex keys
in a secure place; one of the hex keys is used to adjust the walking belt (see pages 29 and 30). To protect
the floor or carpet from damage, place a mat under the treadmill.
75 Ohm
Terminal
Audio/
Video
Input
Jack
101
9. Orient the Storage Latch (78) so that the large
barrel and the Latch Knob (77) are in the posi-
tions shown.
Remove the tie from the upper end of the
Storage Latch (78). Attach the upper end of the
Storage Latch to the bracket on the Frame (61)
w
ith a 3/8" x 1 3/4" Bolt (5) and a 3/8" Nut (9).
Remove the tie from the lower end of the
Storage Latch (78). Keep the holes in the Latch
Cap (79) aligned with the holes in the Storage
Latch. Make sure to keep the Latch Cap in-
side the Storage Latch. Attach the Storage
Latch to the bracket on the Base (115) with a
3/8" x 2" Bolt (6) and a 3/8" Nut (9). Note: It may
be necessary to move the Frame back and forth
to align the Storage Latch with the bracket.
Lower the Frame (61) (see HOW TO LOWER
THE TREADMILL FOR USE on page 27).
9
9
Large
Barrel
115
79
6
6
1
9
5
77
78