Filter
Top Products
11. Press a 1Ó Round Inner Cap (36) into one of the
Press Arms (6). Press a 1 3/4Ó Square Inner Cap
(65) into the Press Arm.
Repeat this step for the other Press Arm (6).
12. Identify the Right Butterfly Arm (15) and the Left
Butterfly Arm (14). Note the position of the welded
bracket on each Arm. Butterfly Arm identification
is very important for step 13.
Attach a Pulley (41) and a Cable Trap (67) to the
Right Butterfly Arm (15) with a 3/8Ó x 2Ó Bolt (43)
and a 3/8Ó Nylon Locknut (39) but do not fully
tighten the Nylon Locknuts yet.
Attach a Pulley (41) and a Cable Trap (67) to the
Left Butterfly Arm (14) with a 3/8Ó x 2Ó Bolt (43)
and a 3/8Ó Nylon Locknut (39) but do not fully
tighten the Nylon Locknuts yet.
Press 1 3/4Ó Square Inner Caps (65) into the ends
of the Right and Left Butterfly Arms (15, 14). Wet
the lower end of each Arm with soapy water. Slide
a Butterfly Foam Pad (23) onto the lower end of
each Arm.
13. Lubricate the axle on the Right Butterfly Arm (15) .
Slide the axle on the Right Butterfly Arm (15) into
the Frame (2). Note: Be careful not to confuse
the Right Butterfly Arm with the Left Butterfly
Arm (14); refer to step 12 to identify the Right
Butterfly Arm. Be sure that the upper end of
the Right Arm is behind the indicated bracket
on the Frame (2).
IMPORTANT NOTE: Before assembling the 3/4Ó
Retainers (70) be sure that you thoroughly
understand the step. The Retainers can be
assembled only once. If they must be removed,
you will need to order new Retainers.
Slide a 3/4Ó Large Washer (71) onto the axle on
the Right Butterfly Arm (15). Tap two 3/4Ó
Retainers (70) and a 3/4Ó Round Cover Cap (69)
onto the axle. Be sure that the teeth on the
Retainers bend toward the Cover Cap, as
shown in the inset drawing.
Attach the Left Butterfly Arm (14) in the same
manner.
11
36
65
6
65
36
6
12
24
24
43
13
9
69
70
70
71
71
2
14
Lubricate
Axles
Axle
15
Bracket
69
70
71
67
65
65
39
41
65
14
15