Filter
Top Products
14
TROUBLE-SHOOTING AND MAINTENANCE
Inspect and tighten all parts each time you use the home gym system. Replace any worn parts immediately. The
home gym system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.
TIGHTENING THE CABLE
Woven cable, the type of cable used on the home
gym system, can stretch slightly when it is first used.
If there is slack in the cables before resistance is felt,
the cables should be tightened. Slack can be
removed from the Cable (35) by moving the Pulley
(41) to the next hole in the indicated bracket on the
upper end of the Frame (2). Remove the 3/8Ó Nylon
Locknut (39) and the 3/8Ó x 2Ó Bolt (43) from the
Cable Trap (67) and Pulley. Re-attach the Pulley and
Cable Trap to the next hole in the bracket. Be sure
that the Cable Trap is in the proper position and that
the Cable and Pulley move smoothly.
Additional slack can be removed by moving the
Pulley (41) to the upper hole in the indicated bracket
on the back of the Frame (2). Remove the 3/8Ó Nylon
Locknut (39) and the 3/8Ó x 2Ó Bolt (43) from the
Pulley. Re-attach the Pulley to the upper hole in the
bracket. Be sure that the Cable and Pulley move
smoothly.
Note: If a cable tends to slip off the pulleys often,
the cable may have become twisted. Remove the
cable and re-install it.
The cable must be replaced every two years. If the
cable needs to be replaced, see ORDERING
REPLACEMENT PARTS on the back cover of this
manual.
35
35
2
1
67
43
39
2
41
43
39
2
41