Filter
Top Products
12
ADJUSTMENT
The instructions below describe how each part of the home gym system can be adjusted. Refer to the exercise
guide accompanying this manual to see how the home gym system should be set up for each exercise. IMPOR-
TANT: When attaching the lat bar or nylon strap, make sure that the attachments are in the correct start-
ing position for the exercise to be performed. If there is any slack in the cables or chain as an exercise
is performed, the effectiveness of the exercise will be reduced.
37
66
38
35
21
31
CHANGING THE RESISTANCE SETTING
The unique HealthRider
¨
BRS utilizes its own weight
and the weight of the user to provide a wide range of
resistance settings.
Use the Dial Knob (9) on the Lift Tube (11) to find the
approximate amount of resistance based on your
body weight. The window on the far end of the Lift
Tube displays your body weight. Turn the Dial Knob
until the weight displayed is closest to your weight. If
you will be using the low pulley station and will not be
on the machine, select Ò0Ó as your weight.
When Ò0Ó is selected as the body weight, a single
number is displayed in each of the other windows.
This is the pounds of resistance at the low pulley sta-
tion. When you select any other body weight, two
numbers are displayed in each of the other windows.
The first number, in the white area, is the resistance
at every station except the bench press station. The
second number, in the red area, is the resistance at
the bench press station.
To change the resistance setting, first pull back the
Adjustment Knob (33) on the Lift Tube (11). Align the
Knob with the desired resistance setting and release
the Knob. Be sure that the Knob fully locks into place
when you release it. Note: Due to the cable and
pulleys, the amount of resistance at each exercise
station may vary from the weight setting.
ATTACHING THE LAT BAR, ROW BAR, OR
NYLON STRAP TO THE HIGH PULLEY STATION
Attach the Lat Bar (21) to the Cable (35) with a Cable
Clip (38). For some exercises, the Chain (37) should
be attached between the Lat Bar and the Cable with
two Cable Clips. Adjust the length of the Chain
between the Lat Bar and the Cable so the Lat Bar
is in the correct starting position for the exercise
to be performed.
The Nylon Strap (66) and Row Bar (31) can be
attached in the same manner.
9
Resistance
Windows
Body Weight
Window
11
33