Filter
Top Products
14. Cut the plastic zip tie (not shown) from the Cable
(35). Be careful not to damage the Cable.
Pull on the Cable (35) until you have enough slack
to route the Cable around the Pulley (41) attached
to the Right Butterfly Arm (15). Tighten the 3/8Ó x
2Ó Bolt (43). The Cable Trap (not shown) must
be oriented as shown in step 12.
Route the Cable (35) around the Pulley (41) on the
Left Butterfly Arm (14) in the same manner.
15. Pull the remaining slack in the Cable (35) as
shown. Wrap the Cable around a Pulley (41).
Attach the Pulley and a Cable Trap (67) to the Lift
Tube (11) with a 3/8Ó x 2Ó Bolt (43) and a 3/8Ó
Nylon Locknut (39).
16. Attach the Name Plate (7) to the Frame (2) with
two 3/4Ó Tap Screws (62).
17. Insert a 1/4Ó x 3 1/2Ó Carriage Bolt (59) through the
center hole in a Seat Plate (29). Attach the Seat
Plate to the Backrest (22) with two 1/4Ó x 3/4Ó Bolts
(56).
Insert the 1/4Ó x 3 1/2Ó Carriage Bolt (59) through
the indicated hole in the Frame (2). Tighten a 1/4Ó
Nylon Locknut (54) with a 1/4Ó Washer (55) onto
the Carriage Bolt.
Attach the other end of the Backrest (22) to the
Frame (2) with a 1/4Ó Washer (55) and a 1/4Ó x
3.1/2Ó Bolt (58).
14
15
16
17
10
15
14
43
39
67
41
43
41
35
35
11
2
62
7
54
29
59
56
58
55
22
55