Filter
Top Products
5
ASSEMBLY
1
60
60
Before beginning assembly, carefully read the
following information and instructions:
¥ Place all parts of the home gym system in a
cleared area and remove the packing materials;
do not dispose of the packing materials until
assembly is completed.
¥ For help identifying the small parts used in
assembly, use the PART IDENTIFICATION
CHART located in the center of this manual.
Note: Some small parts may have been pre-
attached for shipping. If a part is not in the parts
bag, check to see if it has been pre-attached.
¥ As you assemble the home gym system, be sure
that all parts are oriented as shown in the
drawings.
¥ Tighten all parts as you assemble them, unless
instructed to do otherwise.
THE FOLLOWING TOOLS (NOT INCLUDED) ARE
REQUIRED FOR ASSEMBLY:
¥ Two (2) adjustable wrenches
¥ One (1) phillips screwdriver
¥ One (1) rubber mallet
¥ Lubricant, such as grease or petroleum jelly,
and soapy water will also be needed.
Assembly will be more convenient if you have the
following tools: A socket set, a set of open-end or
closed-end wrenches, or a set of ratchet wrenches.
1. Before beginning assembly, be sure that you
have read and understand the information in the
box above.
Insert four 3/8Ó x 2 1/2Ó Carriage Bolts (60) up
through the Base (1). Note: It may be helpful to
tape the Carriage Bolt heads in place under the
Base. If you do tape the Carriage Bolt heads,
remove the tape once you finish assembly.
1