Filter
Top Products
13
The left side of the dis-
play will show the incline
l
evel of the treadmill, the
elapsed time, and the
d
istance that you have
walked or run. Note:
When a program is selected (except for the fitness
test program and pulse control program 2), the
display will show the time remaining in the pro-
gram instead of the elapsed time.
The right side of the
display will show the
speed of the walking
belt, the approximate
number of calories you
have burned, and your
pace (in minutes per mile). The display will also
show your heart rate when you use the handgrip
pulse sensor or the chest pulse sensor.
Note: The console can display speed and dis-
tance in either miles or kilometers. To determine
which unit of measurement is selected, or to
change the unit of measurement, see THE IN-
FORMATION MODE/DEMO MODE on page 24.
Note: For simplicity, all instructions in this sec-
tion refer to miles.
To reset the display, press the Stop button, re-
move the key, and then reinsert the key.
Measure your heart rate if desired.
To use the chest pulse sensor, see page 9. To
use the handgrip pulse sensor, see the instruc-
tions below. Note: If you use the chest pulse sen-
sor and the handgrip pulse sensor at the same
time, the console will not display your heart rate
accurately.
To use the handgrip pulse sensor, first remove the
sheets of clear plastic from the metal contacts on
the handrail.
Next, stand on
t
he foot rails
and hold the
m
etal contacts—
avoid moving
your hands.
When your pulse
is detected, the
heart symbol in the right side of the display will
appear, one or two dashes will appear, and then
your heart rate will be shown.
For the most accu-
rate heart rate reading, continue to hold the
contacts for about 15 seconds.
Turn on the fan if desired.
To turn on the fan, press the Fan button. To turn
on the fan at high speed, press the button a sec-
ond time. To turn off the fan, press the button a
third time. Note: If the fan is left on when the walk-
ing belt is stopped, the fan will automatically turn
off after a few minutes.
When you are finished exercising, remove the
key from the console.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to the lowest set-
ting. The incline must be at the lowest setting
when the treadmill is folded to the storage posi-
tion or the treadmill will be damaged. Next, re-
move the key from the console and put it in a se-
cure place. Note: If the display remains lit after
the key is removed, the console is in the
“demo” mode. See page 24 and turn off the
demo mode.
When you are finished using the treadmill,
switch the on/off switch to the “off” position
and unplug the power cord.
8
7
6
Contacts