Filter
Top Products
Warnings
WarningsWarnings
Warnings
The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The
exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specic
risks. When these symbols appear in the body of this manual or on warning labels, refer back to these
Warnings. Product-specic hazard symbols and warnings not covered in this section may appear throughout
the body of this manual where applicable.
WARNINGWARNING
WARNING
FIREFIRE
FIRE
ANDAND
AND
EXPLOSIONEXPLOSION
EXPLOSION
HAZARDHAZARD
HAZARD
Flammable fumes, such as solvent and paint fumes, in workwork
work
areaarea
area
can ignite or explode. To help
prevent re and explosion:
• Use equipment only in well ventilated area.
• Eliminate all ignition sources; such as pilot lights, cigarettes, portable electric lamps, and
plastic drop cloths (potential static arc).
• Keep work area free of debris, including solvent, rags and gasoline.
• Do not plug or unplug power cords, or turn power or light switches on or off when ammable
fumes are present.
• Ground all equipment in the work area. See GroundingGrounding
Grounding
instructions.
• Use only grounded hoses.
• Hold gun rmly to side of grounded pail when triggering into pail. Do not use pail liners unless
they are antistatic or conductive.
• StopStop
Stop
operationoperation
operation
immediatelyimmediately
immediately
if static sparking occurs or you feel a shock, Do not use
equipment until you identify and correct the problem.
• Keep a working re extinguisher in the work area.
Static charge may build up on plastic parts during cleaning and could discharge and ignite
ammable vapors. To help prevent re and explosion:
• Clean plastic parts only in well ventilated area.
• Do not clean with a dry cloth.
• Do not operate electrostatic guns in equipment work area.
ELECTRICELECTRIC
ELECTRIC
SHOCKSHOCK
SHOCK
HAZARDHAZARD
HAZARD
This equipment must be grounded. Improper grounding, setup, or usage of the system can
cause electric shock.
• Turn off and disconnect power at main switch before disconnecting any cables and before
servicing or installing equipment.
• Connect only to grounded power source.
• All electrical wiring must be done by a qualied electrician and comply with all local codes
and regulations.
BURNBURN
BURN
HAZARDHAZARD
HAZARD
Equipment surfaces and uid that’s heated can become very hot during operation. To avoid
severe burns:
• Do not touch hot uid or equipment.
4
3A2096D