Filter
Top Products
Installation
FluidFluid
Fluid
LineLine
Line
AccessoriesAccessories
Accessories
Install the following accessories in the order shown
in Fig. 1, using adapters as necessary. All uid
lines and accessories must be rated to the maximum
working pressure of 400 psi (2.8 MPa, 28.0 bar).
• FluidFluid
Fluid
draindrain
drain
valvevalve
valve
(D):(D):
(D):
required in your system, to
relieve uid pressure in the hose and circulation
system.
• FluidFluid
Fluid
pressurepressure
pressure
gaugegauge
gauge
(E):(E):
(E):
for more precise
adjustment of the uid pressure.
• FluidFluid
Fluid
shutoffshutoff
shutoff
valvevalve
valve
(F):(F):
(F):
shuts off uid ow.
FillFill
Fill
WithWith
With
OilOil
Oil
BeforeBefore
Before
UsingUsing
Using
EquipmentEquipment
Equipment
See Fig. 5. Before using the equipment, open the ll
cap (P) and add Graco Part No. 16W645 ISO 220
silicone-free synthetic gear oil. Check the oil level in
the sight glass (K). Fill until the oil level is near the
halfway point of the sight glass. The oil capacity is
approximately 1.5 quarts (1.4 liters). DoDo
Do
notnot
not
overll.overll.
overll.
NOTE:NOTE:
NOTE:
Two 1 quart (0.95 liter) bottles of oil are
supplied with the equipment.
Figure 5 Sightglass and Oil Fill Cap
FlushFlush
Flush
BeforeBefore
Before
UsingUsing
Using
EquipmentEquipment
Equipment
The pump uid section was tested with lightweight
oil, which is left in the uid passages to protect parts.
To avoid contaminating your uid with oil, ush the
equipment with a compatible solvent before using
the equipment.
ControlControl
Control
ModuleModule
Module
AccessoryAccessory
Accessory
The Control Module Accessory is required with
Advanced E-Flo DC motors to provide the interface
for users to enter selections and view information
related to setup and operation. See the Control
Module Accessory Kit manual for installation and
operation information.
12
3A2096D