Filter
Top Products
Installation
ConnectConnect
Connect
thethe
the
PowerPower
Power
SupplySupply
Supply
Improper wiring may cause electric shock or other
serious injury if work is not performed properly.
Have a qualied electrician perform any electrical
work. Be sure your installation complies with all
National, State and Local safety and re codes.
1. Ensure that the fused safety switch (B, Fig 2) is
shut off and locked out.
Figure 2 Locked Out Fused Safety Switch
2. See Fig. 3. Install a start/stop control (C) in the
electrical supply line (A), within easy reach of
the equipment. The start/stop control must be
approved for use in hazardous locations.
3. Open the electrical compartment (S) on the
motor.
4. Bring the power wires into the electrical
compartment through the 3/4–14 npt(f) inlet port.
Connect the wires to the terminals, as shown.
Torque the terminal nuts to 25 in-lb (2.8 N•m)
maximum. DoDo
Do
notnot
not
over-torque.over-torque.
over-torque.
5. Close the electrical compartment. Torque the
cover screws to 15 ft-lb (20.3 N•m).
Figure 3 Connect the Power Wires
NotesNotes
Notes
forfor
for
Fig.Fig.
Fig.
33
3
Tighten all terminal nuts to 25 in-lb (2.8 N•m)
maximum. DoDo
Do
notnot
not
overover
over
--
-
torque.torque.
torque.
Tighten cover screws to 15 ft-lb (20.3 N•m).
A conduit seal (D) is required within 18
in. (457 mm) of the motor for the US and
Canada.
103A2096D