Filter
Top Products
14
16.
Orient a Press Arm Handle (17) with the 90° bend
at the top as shown in the inset drawing.
Attach a
Press Arm Handle (17) to the Right Press Arm
(16) with two M10 x 65mm Button Bolts (106),
four M10 Washers (80), four 11mm Spacers (99),
and two M10 Nylon Locknuts (77).
Repeat this step for the Left Press Arm (not
shown).
17.
Attach the Left Press Arm (15) to the Right Press
Arm (16) with an M10 x 1
10mm Bolt (93), an
89.5mm Spacer (59) and an M10 Nylon Locknut
(77).
Finish attaching the Press
Arms with two M10 x
65mm Bolts (85), two M10 Washers (80), and two
M10 Nylon Locknuts (77).
Do not tighten the
Nylon Locknuts yet.
17
16
15
77
77
59
93
80
85
106
16
99
99
99
80
80
77
99
80
80
17
16
90° Bend
90°
Bend
15. Grease in the locations shown and attach the
Right Butterfly Arm (26) to the Right Butterfly
B
racket (29) with an M10 x 75mm Bolt (82) and
an M10 Nylon Locknut (77). Press a Bolt Cap
(
44) onto the end of the Bolt. D
o not overtighten
the Bolt; the Butterfly Arm must pivot easily.
Repeat this step for the Left Butterfly Arm (25).
1
5
25
29
77
82
26
44
Grease