Filter
Top Products
10
4. Attach the Frame (9) to the Upright (2) with two
M8 x 80mm Bolts (100), two M8 Washers (103),
a
nd two M8 Nylon Locknuts (78). D
o not tighten
the Nylon Locknuts yet.
Attach the Frame (9) to the Front Leg (10) with
two M8 x 65mm Bolts (101), two M8 Washers
(103), and two M8 Nylon Locknuts (78). Do not
tighten the Nylon Locknuts yet.
4
100
100
2
103
103
78
7
8
78
78
9
101
103
10
5. Attach the bottom of the Left Shroud (21) to the
Base (1) with two M4 x 12mm Self-tapping
Screws (102).
Repeat this step for the Right Shroud (not
shown).
6. Note: Some parts are not shown to show this
step clearly.
Slide the two Weight Bumpers (71) onto the
Weight Guides (18). Orient nine Weights (19) with
the pin holes on the bottom as shown. Slide the
Weights onto the Weight Guides.
Insert the Weight Selector (20) into the nine
Weights (19).
Make sure that the pin on the
W
eight Selector is oriented as shown.
Lubricate the indicated holes in a Weight (19)
with the included grease packet. Slide the Weight
onto the W
eight Guides (18).
6
19
71
19
20
18
Pin
Pin
Hole
Grease
5
102
21
1