Filter
Top Products
27
Lower the treadmill (see HOW TO LOWER THE
TREADMILL FOR USE on page 25). Remove the
four indicated #8 x 3/4" Screws (1), and remove
the Motor Hood (75).
Next, locate the Reed Switch (53) and the Magnet
(58) on the left side of the Pulley (59). Turn the
Pulley until the Magnet is aligned with the Reed
Switch. Make sure that the gap between the
Magnet and the Reed Switch is about 1/8 in. (3
mm). If necessary, loosen the indicated #8 x 3/4"
Tek Screw (24), move the Reed Switch slightly,
and then retighten the Screw. Then, reattach the
Motor Hood (not shown) with the six #8 x 3/4"
Screws (not shown), and run the treadmill for a few
minutes to check for a correct speed reading.
SYMPTOM: The incline of the treadmill does not
change correctly
a. Recalibrate the incline system (see step 4 on page
22).
SYMPTOM: The walking belt slows when walked on
a. Use only a single-outlet surge suppressor that
meets all of the specications described on page
12.
b. If the walking belt is overtightened, treadmill per-
formance may decrease and the walking belt may
become damaged. Remove the key and UNPLUG
THE POWER CORD. Using the hex key, turn both
idler roller screws counterclockwise, 1/4 of a turn.
When the walking belt is properly tightened, you
should be able to lift each edge of the walking belt
3 to 4 in. (8 to 10 cm) off the walking platform. Be
careful to keep the walking belt centered. Then,
plug in the power cord, insert the key, and run the
treadmill for a few minutes. Repeat until the walk-
ing belt is properly tightened.
c. Your treadmill features a walking belt coated with
high-performance lubricant. IMPORTANT: Never
apply silicone spray or other substances to the
walking belt or the walking platform unless in-
structed to do so by an authorized service rep-
resentative. Such substances may deteriorate
the walking belt and cause excessive wear. If
you suspect the walking belt needs more lubricant,
see the front cover of this manual.
d. If the walking belt still slows when walked on, see
the front cover of this manual.
1
75
1
Top
View
24
53
1/8 in.
59
58
Idler Roller Screws
b
3–4 in.