Filter
Top Products
22
HOW TO USE THE MAINTENANCE MODE
The console features a maintenance mode that allows
you to update the console firmware, calibrate the in-
cline of the treadmill, calibrate the screen, view techni-
cal information, and view a button’s keycode.
1. Select the settings main menu.
See step 1 on page 21.
2. Select the maintenance mode.
In the settings
main menu,
touch the
Maintenance
button to enter
the mainte-
nance mode.
The maintenance mode main screen will show
information about the model and version of the
treadmill.
3. Update the console firmware.
For the best results, regularly check for firm-
ware updates.
Touch the Firmware Update button to check for
firmware updates using your wireless network. The
update will begin automatically.
To avoid damaging the treadmill, do not turn
off the power or remove the key while the firm-
ware is being updated.
Note: If you cannot update the console firmware
over your wireless network, you can update the
firmware using a USB drive. Go to www.iFit.com
and download the latest firmware update onto your
USB drive. Safely remove the USB drive from your
computer and plug it into the USB port on the top
of the console. The update should begin
automatically.
The screen will show the progress of the update.
When the update is complete, the treadmill will turn
off and then turn back on. If it does not, press the
power switch into the off position. Wait for several
seconds, and then press the power switch into the
reset position. Note: It may take a few minutes for
the console to be ready for use.
4. Calibrate the incline system of the treadmill.
Touch the Calibrate Incline button. Then, touch the
Begin button to calibrate the incline system. The
treadmill will automatically rise to the maximum
incline level, lower to the minimum incline level,
and then return to the starting position. This will
calibrate the incline system. Press the Cancel but-
ton to return to the maintenance mode. When the
incline system is calibrated, touch the Finish
button.
IMPORTANT: Keep pets, feet, and other objects
away from the treadmill while the incline system
is calibrating. In an emergency, pull the key
from the console to stop the incline calibration.
5. Calibrate the screen.
If the screen is not properly calibrated, it will be dif-
ficult to touch the correct buttons on the screen.
To calibrate the screen, touch the Calibrate Screen
button. A small target will appear on the screen.
Touch the center of the target. Then, touch the rest
of the targets. After several seconds, the console
will exit the calibration mode.
6. View machine information.
Touch the Machine Info button to view information
about your treadmill. After you view the informa-
tion, touch the back button on the screen.
7. Find Keycodes.
This option is intended to be used by service tech-
nicians to identify whether a certain button is work-
ing correctly.
8. Exit the maintenance mode.
To exit the maintenance mode, press the back but-
ton on the console.