Filter
Top Products
29
1 1 5 0 S E R I E S O W N E R’ S M A N U A L
Accepting Default values or Entering the program setting mode
When the USER 1 or USER 2 key is pressed:
1. If no program has been saved into user program before, the
message window will scroll a message “NO SAVED PROGRAM,
SELECT ANOTHER PROGRAM”. User may select another pro-
gram at this time.
2. If a program has been saved into user program before, the mes-
sage window will scroll a message “PRESS ENTER TO ADJUST
OR START TO BEGIN”.
• Press “START/Resume” key to accept the saved setting and
begin workout.
• Or press “ENTER” key to enter program-setting mode.
• It will skip Age and Weight entry and take you through each pro-
gram setting step by step. For each program setting details,
please see its program pages.
During the Program
See each program page for details.
Ending the Program
See each program page for details.
Workout Programs
Maintenance
CAUTION – FOR SAFE OPERATION
Always inspect hardware prior to any exercise session. Look for
loose hardware, loose pedals, loose cranks and frayed wires.
Repair or replace any damaged or worn parts, tighten all loose
hardware.
As part of Diamondback’s normal installation and set-up process,
all pedal cranks must be tightened after 8 to 10 hours of initial
riding to ensure parts are properly seated to axle. This is standard
initial “break-in” service, which must be performed after the first 8
to 10 hours of use. Untightened pedal cranks may become loose,
causing damage, which may void the warranty.
After training, always wipe down your 1150 series unit.
Perspiration that continuously settles on frame, pads or casing
may eventually cause rust or damage to the unit. Damage
resulting from lack of proper maintenance will not be covered
under warranty. To clean pads, use a mild soap and warm water.
Dry with a clean towel.
If noises develop or malfunctions occur, contact your authorized
Diamondback fitness dealer.