Filter
Top Products
8
Replacing Brake Pads
The brake pads on the IC are made of a consumable felt material. Over time, the pads will wear out and need to be replaced.
Follow these steps to replace your brake pads:
Replacing Resistance Knob
With a 5mm Allen wrench, loosen the
cable holding wire on the right hand side
brake arm.
Loosen the pinch bolt that holds the
washers onto the post of the brake
pad.
Remove old pads and hardware from the
brake arms. Pay attention to the orienta-
tion of the washers and spacers as you
remove them.
Insert new brake pads and hardware
exactly as they were positioned prior to
removal.
Align brake pads (see page 7)and
tighten pinch bolts.
Remove water bottle holder by removing
the four screws that hold it on.
Loosen the right hand brass cable stop
until you can remove the cable from
the stop.
Using a Phillips-head screwdriver, loosen
the setscrew on the underside of the
handlebar near the resistance knob. Note:
ICs shipped prior to 2007 use an Allen
bolt for the set screw.