Filter
Top Products
7
Brake Adjustment
Aligning Brake Pads
When aligning the brake pads after replacement or after adjusting the fl ywheel, use the following guidelines for accurate
alignment:
Cable adjustment (under bottle cage)
Proper adjustment of the cables on the sliding splitter should look like this (Fig 1) In the event you need to adjust the cables, use
the following steps:
Ensure the pads sit parallel to the smooth
part of the fl ywheel.
Ensure the top of the pad does not
contact the fl ywheel above the
smooth part of the fl ywheel.
Ensure the pad mimics the curvature of
the fl ywheel. NOTE: Brake pads should
always be touching the fl ywheel.
Release all cable tension in the handlebar
resistance knob.
Using a vice-grips or other clamping
mechanism, secure the bottom lip of
the cable carrier to the bottom of the
carrier assembly.
Using a set of pliers, grasp the end of the
cable that needs adjustment. Loosen the
brass set screw and slide it towards the
top of the cable carrier.
Once the brass set screw is touching the
top of the cable carrier, tighten it securely
onto the cable.
Repeat on other side if necessary.
Fig 1