Filter
Top Products
11. USING THE ALARM MODE
The alarm setting procedure and other procedures for alarm use are the same for Alarm 1, 2 and 3. Only the
tone that sounds is different.
The alarm sounds for 15 seconds when the set time is reached once a day. When the alarm is sounding, it can
be turned off by pressing button (A) or (B).
<Setting the Alarm Time>
1.Turn the crown and set the mode hand to either the Alarm 1, 2 or 3 [AL-1, 2 or 3] mode.
2. Press either button (A) or button (B) to access the city to be corrected.
3. When the crown is pulled out to the second click (alarm time setting position), the watch
enters the alarm correction state.
4. When button (A) is pressed, the location to be corrected changes each time it is pressed. Select the
location to be corrected so that it flashes.
x The alarm can be set (ON) or canceled (OF) by pressing button (B) when the watch is in the alarm
ON/OF correction state.
x When the crown is turned forward (clockwise) in the "hours" or "minutes" correction state, correction is
made in the positive direction. When the crown is turned backward (counter-clockwise), correction is
made in the negative direction.
x Turning the crown continuously allows corrections to be made rapidly.
5. After corrections have been completed, return the crown to the normal position.
Note:
1. When the time mode is set to the 12-hour time display, the alarm time also uses a 12-hour time display.
Pay attention to AM and PM when setting the alarm time.
Return to Table of Contents
Return to Table of Contents