6
O
N
O
F
F
1. Attaching the front leg
• Remove the two screws from the re-
spective leg pipes. The one with
casters should be used as front leg.
• Place the front leg under the front
end of the main body with casters
facing forward, and adjust the posi-
tion so that the screw holes meet the
fastening points.
• Fasten the leg with the two screws
securely.
Assembly
2. Attaching the rear leg
• Place the rear leg pipe under the
rear end of the main body, and ad-
just the position so that the screw
holes meet the fastening points.
• Fasten the leg with the two screws
securely.
3. Mounting the handlebar
post
• Remove the handlebar post knob.
• Insert the handlebar post into the
main body, with the post holes fac-
ing forward.
• Adjust the handlebar height so that
one of the post holes meets the post
knob screw hole, and fasten the post
knob securely. It will be easier to
screw in if you slightly lift the han-
dlebar post.
5
caster
Front
screw
leg pipe
screw
Rear
leg pipe
1
3
7
CAUTION: If the pedals are not
attached firmly enough to the
crank, they can cause an irritat-
ing noise. Be sure to attach
them firmly.
handlebar post
loosen
tighten
handlebar post knob
4. Mounting the saddle
• Pull the spring lock pin and lift up
the seat post to a proper height for
saddle mounting.
• Mount the saddle on the seat post,
and use the wrench No.13 provided
to tighten both nuts firmly.
5. Attaching the pedals
• Use the No.15 end of the spanner to
attach the pedals firmly to the
cranks.
• The right and left pedals are differ-
ent, so be sure to check for R and L
marks.
• Tighten the right pedal by turning
clockwise, and the left pedal by
turning counterclockwise.
seat post
wrench No.13
left (L) right (R)
crank
wrench No.15
4
2
Front
EC-1200
O
N
O
F
F