Filter
Top Products
18
Bowflex Xtreme
®
2 SE Assembly Manual
Assembly Guide
Step 19 Cable and Pulley
Routing – Connect Rod
Cables through the Right
Floating and Lat Tower
Pulleys
Locate the following items for the
Lat Pulley Housing assembly:
• 3 & 8 Floating Pulleys (connected
unit)
• (2) Cable End Stop Balls with
Core (see Detail)
19-1 Locate the Right Rod Cable
that you ran through the
Lat Pulley Housing. Thread
the Cable through the (3)
Floating Pulley, as shown.
19-2 Continue to guide the Cable
through the (4) Pulley on
the Rear Lat Cross Bar, and
then through the (5) Pulley
on the Front Lat Cross Bar as
shown.
19-3 Insert the Cable End
through the Cable End Stop
Ball, and attach the Cable
Core to keep the Cable from
slipping back through the
Pulleys. See Figure 19b
.
Note: The Cable End Stop Ball
Core should fit over the
Ferrue when installed
correctly. Rotate the Core
to align it with the groove
in the Ball.
5
4
3
2