Filter
Top Products
14
Bowflex Xtreme
®
2 SE Assembly Manual
Step 15 Install Upper Lat Tower Assembly,
Ab Crunch Station and Lat Pulley
Parts:
• Upper Lat Tower Assembly
• Ab Crunch Station
• Lat Pulley Housing
• Main Assembly
Hardware:
• 5 Button Head Screws (3/8" X 3/4")
• 5 Flat Washers (3/8
")
Tool: 7/32" Hex Wrench
15-1 Slide the Upper Lat Tower Assembly onto the
Lower Lat Tower as shown.
15-2 Place the Ab Crunch Bracket against back of the
Lat Tower Assembly. Align the bolt holes on the
Ab Crunch Bracket’s side flaps with the lower bolt
holes on the sides of the Lat Tower.
15-3 To attach the Ab Crunch Station to the Lat
Tower, install a 3/4” screw and washer through
the upper bolt hole on the Ab Crunch Station
into the back of the Lat Tower as shown in
Detail
15a. Secure the Ab Crunch Station to the sides of
the Lat Tower with 2 screws and washers as shown
in
Detail 15a.
15-4 Remove the plastic cap from the end of the the
long bolt already installed in the back of the Lat
Pulley/Housing. Finger tighten the bolt–it will be
removed and reinstalled during Step 17 and 18.
15-5 Position the Lat Pulley Housing bracket against
the Lat Tower, over the Ab Crunch Station. Align
the bolt holes as shown in Figure 15b
.
15-6 Place one washer over the end of each screw.
Attach the Lat Pulley Housing to the Lat Tower by
installing the screws loosely into the aligned holes
as shown in Figure 15b
.
Do not tighten hardware at this time.
Ab Bracket on
Lat Tower
Assembly Guide
Detail
15a
Figure 15b
Figure 15a
Lat Pulley Housing
Long Bolt
Flat Washer
Button Head Screw
Washer