Filter
Top Products
STEP
3
A. See Note 1. Install all four handles (K, L, M, and N) on to seat braces (H) and back braces (J).
Install as shown and described using:
eight 26 (hex bolt 10mm x 40mm full thread)
sixteen 36 (flat washer 10mm)
eight 32 (nylon lock nut 10mm)
B. Install seat pad (P) on to both seat braces (H). Tighten pad bolts to a snug fit. Do not
over-tighten any pad bolts. Over-tightening pad bolts will cause T-nuts in pads to strip out. Install using:
four 30 (hex bolt 8mm x 60mm partial thread)
four 37 (spring lock washer 8mm)
four 38 (flat washer 8mm)
C. Install back pad (Q) on to both back braces (J). Tighten pad bolts to a snug fit. Do not over-tighten any
pad bolts. Over-tightening pad bolts will cause T-nuts in pads to strip out. Install using:
four 30 (hex bolt 8mm x 60mm partial thread)
four 37 (spring lock washer 8mm)
four 38 (flat washer 8mm)
7
mm
Inch
Be careful to assemble all components
in the sequence they are presented.